Equipment technical specifications:
Model: BLS-LB400-4M
Description: A system fixed between the payout and take-up devices, including those used for payout The reel And mold seat plate. The mold seat plate can adjust its height and tilt position. The specially designed guide device can adjust the position of the insulation wire to be tangent to the cable. One axis can adjust the mold seat to be set at the entry point of the winding belt (this mold seat can be adjusted) Choose according to user specifications) Install the reel and breakage of the tape, as well as the tape detector together. The gasket/reel is installed vertically, i.e. on a horizontal axis. The pneumatic shaft is faster. Easy to load/unload P>
Axis size: The design of the reel matches the dimensions of the following gaskets or reels P>
Diameter: 300mm maximum (padded to 550mm)
Shaft diameter: 76mm minimum
Width: 330mm maximum
Weight: 56 daN maximum
Tape models: aluminum tape, plastic tape, polyester tape, PP special boiling dragon, paper tape, etc
Thickness range: 20-40 microns
Width: minimum 12 mm/maximum 40 mm
Tension: The tension of the tape is automatically adjusted during the unwinding process, and it is transmitted close to the end The sensor controls the position of a spring loaded adjustment roller to measure the winding belt The degree of elasticity. According to this tightness, connect the vectors to four AC motors The drive ensures a stable tightness. -The tension of the belt can be changed by adjusting the adjustable resistor. -Determine the range of tension based on the different types of springs used: 0.5 to 2.5DaN 1.5 to 5.0 DaN 2.5 to 10.0 DaN
-Maximum linear speed -100 m/min with Max Tension 10 DaN When the maximum tension is 10 DaN, the linear speed is 100 meters/minute -When the maximum tension is 5 DaN, the linear speed is 100 meters/minute